Raw Materials' Price of Hospital Door Manufacturer Is Like The Roller Coaster

Recently, due to the environmental storm, not only many small raw material workshops have been banned, but also many large raw material suppliers have been closed for rectification, such as aluminum alloy profiles, glass, panels and the use of medical doors on packaging cartons. Cause medical door raw material price fluctuation. On average, the carton with medical door added CNY20 per door. As a result, it directly affects the cost and price of the medical door, but TSTC has such a large inventory of all the raw materials and hardware for the medical door, as well as tens of thousands of sets of stocks to ensure supply and demand.

Due to its high value and complex structure, the medical door is more stringent than the ordinary door in terms of safety management. When handling the medical door, medical institutions should strictly follow the scrap process and complete the scrap procedures to eliminate arbitrary disposal and overtime service. For the medical door with reusable value, the medical door manufacturer must do a good job in the process of re-use medical door evaluation, testing and post-use monitoring, to prevent the occurrence of safety incidents. Good waste management of medical door can make the discarded medical door create better use value for medical institutions in the life cycle.

The size of the smooth automatic door machine series is very important. Make it clear when communicating with customers. If the size is not right, it will not be installed. Then, TSTC will teach us how to measure the size of the medical door.

1. Width. refers to the width of the door. Same as the measured height, from the top of the meter to the end of the door to obtain the width dimension.

2. Thickness. refers to the thickness of the wall. The left, upper and upper points of the wall need to be measured to take an average during the measurement.

3. Height. refers to the height of the door. When measuring, the end of the instrument should be raised to the height of the hole and then perpendicular to the ground. Dimension units shall be accurate to millimeter.